The AM Forum
December 09, 2024, 06:30:48 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Calendar Links Staff List Gallery Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: FET drain bypass caps  (Read 6368 times)
0 Members and 1 Guest are viewing this topic.
GW0FZY
Member

Offline Offline

Posts: 28


« on: February 25, 2018, 05:32:44 AM »

Chaps,
I had quite a bit of difficulty finding the UTC porcelaine caps recommended for the drain bypass in the RF deck. Could not find anyone in the UK who had them and they were going to cost a bit if I had to have them sent over from America.
I used these large ceramic SMD’s in parallel soldered togther with some copper foil and they seem to work up to the full output power. If anyones interested here’s the info from Farnell
http://uk.farnell.com/vishay/vj2525d271kxoat/cap-rf-hi-q-270pf-2-5kv-2525/dp/2420175RL

Justin
GW0FZY
Logged
steve_qix
Contributing
Member
*
Offline Offline

Posts: 2597


Bap!


WWW
« Reply #1 on: February 26, 2018, 10:27:49 PM »

Do you mean the shunt caps (the ones that run from the drain bus to ground) ?     These are usually between 1000pF and 1500pF for 4 to 6 FETs per module, on 75 meters.

The bypass caps are the .15uF (or thereabouts) capacitors.  These too must be able to handle the current.  I use 3 .047uF orange drop caps in parallel on each module for RF bypassing.
Logged

High Power, Broadcast Audio and Low Cost?  Check out the class E web site at: http://www.classeradio.org
GW0FZY
Member

Offline Offline

Posts: 28


« Reply #2 on: February 27, 2018, 01:26:31 AM »

Yes the ceramic shunt caps Steve, that's what I meant!!
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands
 AMfone © 2001-2015
Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Page created in 0.066 seconds with 18 queries.