I'm finishing up the second stage of rebuilding the power supply for my ART-13. So far I've added new HV capacitors, new LV transformer, filter and bleeder network and also have done some general housekeeping. It seems that I did not take a picture of the original configuration of the LV filter/rectification network and so I went off of the schematic that came with the supply. Before I fire it up does everything in the photo below look wired properly?
To make it easier to understand there are five terminals on each terminal strip. On the left terminal strip, starting from the top, the connections are:
1) Ground end of bleeder network and jumper connected to terminal 3 (ground)
2) Secondary of LV transformer, rectifier diodes connect here
3) Ground (terminal 1 connects to this)
4) Secondary of LV transformer, rectifier diodes connect here
On the right terminal strip, starting from the top, the connections are:
1) Positive side of filter cap network, LV voltage output feed going to rear panel (orange wire), jumper wire connecting to bleeder network (red wire)
2) LV choke, rectifier diodes connect here
3) Ground, negative side of filter cap network and rectifier diodes connect here
4) Bleeder network connected to terminal 1 (via red wire)
Image:
http://imageshack.us/a/img819/2627/dsc01401mz.jpgSchematic:
http://imageshack.us/a/img39/7402/powersupply.jpg