The AM Forum
May 01, 2024, 02:25:14 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Calendar Links Staff List Gallery Login Register  
Pages: [1]   Go Down
« previous next »
  Print  
Author Topic: General radio modulation monitor  (Read 1817 times)
0 Members and 1 Guest are viewing this topic.
k5ygc
Member

Offline Offline

Posts: 67
« on: February 07, 2012, 03:03:37 PM »
Can anyone tell me what jacks are used for the 600 ohm audio output? They look like 1/4 phono but not sure.

* $(KGrHqZ,!pEE63YiDEB-BO1n!QwVNw~~60_3.jpg (72.48 KB, 800x410 - viewed 463 times.)
Logged
W7TFO
WTF-OVER in 7 land Dennis
Contributing
Member
*
Offline Offline

Posts: 2525


IN A TRIODE NO ONE CAN HEAR YOUR SCREEN


WWW
« Reply #1 on: February 07, 2012, 03:25:01 PM »
The front panel double jack is usually used with a WECo type headset for monitoring test.  In reality, one tip carries the audio, the other is at ground.  It is unbalanced 600Z.

The feed to your amp/speaker is on the Jones receptacle on the rear apron.  There is a shorting link in it to activate internals, must have it in place.

Pete WA2CWA here on the forum sells the manual for it, PM him.

73DG
Logged
Just pacing the Farady cage...
Pages: [1]   Go Up
  Print  
The AM Forum  > THE AM BULLETIN BOARD > Technical Forum > Topic: General radio modulation monitor
 « previous next »
 
Jump to:  

AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands
 AMfone © 2001-2015
Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Page created in 0.085 seconds with 18 queries.