Warning: Creating default object from empty value in /homepages/11/d132647312/htdocs/Amfone/mkportal/include/SMF/smf_out.php on line 47
Low level audio compression driven by High level diode network.




 
The AM Forum
February 23, 2018, 07:05:40 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Calendar Links Staff List Gallery Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: Low level audio compression driven by High level diode network.  (Read 97197 times)
0 Members and 1 Guest are viewing this topic.
IN3IEX
Member

Offline Offline

Posts: 128


« on: January 05, 2012, 06:57:15 AM »

There are various methods for producing AM modulated signals. Each one may require its own preferred audio processing limiter.
Focusing on transformer plate modulated transmitters with abundant audio power, the limiting factor is that the anode voltage of the RF class C output tube cannot receive negative voltage. It is indeed a fact that this voltage should not go below about 40 V for tetrodes, otherwise the output AM envelope is flat zero.
Obviously a pure high voltage resistor and diode network cannot fully correct this kind of overmodulation, it will only mitigate the effects, but the envelope will become distorted if overmodulation occurs.
Low level compressors do indeed work, but they have to be tuned with the oscilloscope and the tuning will depend on the loading on the RF output tube. In fact the high level modulation voltage depends on the anode impedance of the RF tube as seen by the modulation transformer and the audio amplifier.
The clever solution is to "detect" and "partially correct" overmodulation with a diode-resistor high level network and use some signal derived form this networ for controlling a low level audio compressor.
The end result is that it works. It does exactly what it should do. If the audio amplifier does not saturate by its own limitations, modulation will never exceed 99% (if you set it so), for any loading condition of the RF output stage.

This is the result of discussion, design and experiments.

Follow the story here:
http://amfone.net/Amforum/index.php?topic=29655.0
Go to the technical proposal here:
http://www.ing.unitn.it/~fontana/AM%20ALC.pdf
The proposal has been fully tested with success. It was designed with a "vintage mind"; using a filament lamp (like the fist H.P. audio oscillator) instead of a LED, it could certainly be a 1960 design...

IN3IEX Giorgio

Old Italian Buzzards net - www.ik0lrg.it and the boatanchors-net google group


* IN3IEX AM ALC.JPG (55.69 KB, 1179x643 - viewed 1035 times.)
Logged
N2DTS
Contributing
Member
*
Offline Offline

Posts: 2307


« Reply #1 on: September 25, 2013, 11:30:23 AM »

Very interesting!
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands
 AMfone 2001-2015
Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Page created in 0.17 seconds with 18 queries.