The AM Forum
October 10, 2024, 01:10:09 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Calendar Links Staff List Gallery Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: T-368 blower noise reduction  (Read 10932 times)
0 Members and 1 Guest are viewing this topic.
W9RAN
Member

Offline Offline

Posts: 70


« on: June 18, 2023, 04:04:21 PM »

I'd like to quiet down the blower on my T-368 but don't want to create new problems with inadequate airflow.  Any recommendations?
Thanks and 73,
Bob W9RAN
Logged
Todd, KA1KAQ
Administrator
Member

Offline Offline

Posts: 4244


AMbassador


« Reply #1 on: June 18, 2023, 04:33:34 PM »

Hey Bob -

It's been a while, so please bear with me. Haven't been on here or much of anywhere else with any regularity, and of course the ol' gray matter isn't quite as resilient as it once was.

Thinking back to past conversations on the old T-368 list run by that Foley guy (aka beehive kicker), I seem to recall many guys just removed the big blower completely. That's the case with mine. The reasoning being, The forced air was only required for constant key down service ala RTTY which is what they were apparently used for initially. In typical intermittent amateur service the consensus was that forced air wasn't needed for a single 4-400 - the cabinet, chassis, and adequate airspace could remove the heat well enough. Of course, if you have the Tron over for a visit and he gets on the air to discuss Ranger mods, well....all bets are off.

With that said, I do intend to add one of those larger (8 inch?) Rotron whisper fans to mine just to establish and aid in the overall airflow. They don't suck much juice and make virtually no noise, so I figure it can't hurt?

Hope you are well, my friend. It's been a few days....

Logged

known as The Voice of Vermont in a previous life
W9RAN
Member

Offline Offline

Posts: 70


« Reply #2 on: June 19, 2023, 12:33:15 PM »

Hey Todd,  yes it has!   Hope you're doing well also.  I know others who have said the same, so I think I'll pull the blower off and see what might be suitable that will move some air but be a bit quieter.   Just thought someone might know of a go-to replacement. 

Bob
Logged
W3SLK
Member

Offline Offline

Posts: 2687

Just another member member.


« Reply #3 on: June 19, 2023, 05:38:16 PM »

Is there a way to place a muffin fan in there with just enough ummph to start convection cooling?

Logged

Mike(y)/W3SLK
Invisible airwaves crackle with life, bright antenna bristle with the energy. Emotional feedback, on timeless wavelength, bearing a gift beyond lights, almost free.... Spirit of Radio/Rush
Pages: [1]   Go Up
  Print  
 
Jump to:  

AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands
 AMfone © 2001-2015
Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Page created in 0.047 seconds with 19 queries.