The AM Forum
November 10, 2024, 06:27:46 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Calendar Links Staff List Gallery Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: Problem With Post  (Read 14523 times)
0 Members and 1 Guest are viewing this topic.
W9ZSL
Contributing
Member
*
Offline Offline

Posts: 748


« on: May 07, 2019, 02:11:52 PM »

I started a thread in Technical regarding Driver Transformer Ratios. I wrote a reply and added some info including diagrams and a pix of the monitor. Must have done something wrong because I'm "locked out" of the topic. When I click on it, all I get is a blank screen.  Mike W9ZSL
Logged
KK4YY
Member

Offline Offline

Posts: 565


Your best isn't as good as you can be.


« Reply #1 on: May 07, 2019, 03:29:13 PM »

Same here. Blank page.
Logged

All your worries won't add a day to your life, or make the ones you have any happier.
Opcom
Patrick J. / KD5OEI
Contributing
Member
*
Offline Offline

Posts: 8296



WWW
« Reply #2 on: May 07, 2019, 06:51:00 PM »

I answered to put 2660 Ohms across each half of the secondary if using 325V and expecting 12K plate to plate load. But that's gone as well.
Logged

Radio Candelstein
W9ZSL
Contributing
Member
*
Offline Offline

Posts: 748


« Reply #3 on: May 08, 2019, 11:29:37 AM »

Since the test calls for using the entire secondary, I figured out that 5K plus a 20 ohm wire-wound pot would do the job. One leg of the pot and one side of the secondary is grounded. All I have to do is lift the center tap from ground and plug in the resistor/pot combo and that should do it! Thanks!
Logged
w3jn
Johnny Novice
Administrator
Member

Offline Offline

Posts: 4612



« Reply #4 on: May 09, 2019, 05:41:21 PM »

Guys, sorry about this.  No idea what happened or why; it has happened before but very rarely.  No way to recover the thread that we know of.

I deleted the thread, suggest you re-start it.
Logged

FCC:  "The record is devoid of a demonstrated nexus between Morse code proficiency and on-the-air conduct."
W9ZSL
Contributing
Member
*
Offline Offline

Posts: 748


« Reply #5 on: May 10, 2019, 12:01:13 PM »

Probably something I did when trying to make attachments. This happened once before. At any rate, problem is solved. I found a 5K, 20 watt resistor that should work just fine for the test of the driver.  73!
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands
 AMfone © 2001-2015
Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Page created in 0.179 seconds with 19 queries.