The AM Forum
December 05, 2024, 01:38:51 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Calendar Links Staff List Gallery Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: grid and plate current reading with no meter... pilot lamp  (Read 1548 times)
0 Members and 1 Guest are viewing this topic.
W4AMV
Member

Offline Offline

Posts: 706


« on: April 01, 2021, 03:06:51 PM »

Used this on a novice rig as a kid.
Forgot the details and cannot recall if it used link coupling
to the oscillator driver tank and the plate tank. Or just in series
as shown here with the grid leak return and HV to the plate.
 
I recently found that arrangement in a 1950 handbook for a mobile rig.
Schematic attached.

Any folks on the forum use this for peaking the grid drive and
dip and loading plate current? A
s I recall, it worked great. I believe
it used a #47 dial lamp. Same lamp used to peak oscillator drive.
I am short on meters, so looking at giving this a try in a transmitter
under construction.

Any issues with HV flash over. The unit documented in the handbook is at 300V.
How high a V before an incandescent lamp like a #47 flashes over? I think my 6DQ5 was on 500V.

Thanks, Alan


* pilot_lamp_gridandplate_current.jpg (40.55 KB, 659x481 - viewed 442 times.)
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands
 AMfone © 2001-2015
Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Page created in 0.041 seconds with 19 queries.