The AM Forum
December 12, 2024, 12:42:45 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Calendar Links Staff List Gallery Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: What To Do w/250 ma AC Meter  (Read 2743 times)
0 Members and 1 Guest are viewing this topic.
W9ZSL
Contributing
Member
*
Offline Offline

Posts: 748


« on: July 15, 2019, 05:45:03 PM »

 Roll Eyes Dumb me. Misread the ad. Bought a Triplett 250 Milliamp Meter.  Unfortunately it's AC. Thought it was DC.  Tongue Now I don't quite know what to do with it! I was going to use it with a 1 KV, 250 ma supply; bridge rectifier. Is there a way to wire it into the secondary? Must be Monday.
Logged
PA0NVD
Member

Offline Offline

Posts: 615


Nico and Chappie (Chappie is the dog...)


« Reply #1 on: July 15, 2019, 05:55:11 PM »

try it at DC, may work fine. Perhaps just needs a little calibration adjustment
Logged
w4bfs
W4 Beans For Supper
Contributing
Member
*
Offline Offline

Posts: 1434


more inpoot often yields more outpoot


« Reply #2 on: July 16, 2019, 08:59:15 AM »

Nico may have something .... custom meters can be most anything  Huh Huh .... rig up a series circuit of a battery, variable resistor, dmm set to measure current and the meter under test ....  start at 50 microAmps current and decrease resistance allowing more current to flow .... if this still gives garbage results, carefully remove the 3 (usually) screws that retain the movement in the case .... you may find an internal shunt resistance or much more rarely a rectifier, etc
Logged

Beefus

O would some power the gift give us
to see ourselves as others see us.
It would from many blunders free us.         Robert Burns
W9ZSL
Contributing
Member
*
Offline Offline

Posts: 748


« Reply #3 on: July 17, 2019, 01:35:14 PM »

I certainly would like to salvage it. It's brand-new, in the box complete with all the hardware.
Logged
Opcom
Patrick J. / KD5OEI
Contributing
Member
*
Offline Offline

Posts: 8301



WWW
« Reply #4 on: July 22, 2019, 11:55:55 AM »

Monitor your workbench or variac output voltage by adding a step down transformer from 240V to 24V@1A, and put a 100 Ohm 10W resistor in series with the meter, and put that series combination across the 24V winding so 0-240V reads 0-240. There will always be some error but it works well, adjust the 100 Ohm resistor to calibrate it at the spot you care about most.

Monitor a filament voltage choosing a resistor that gives a reading in center scale. A 60 Ohm 3W unit for a 7.5V filament, to read '125'.

Use a 100:1 current transformer to measure 25 AC amps (as 0-250) on your work bench 120V variac or outlet. - best use!

change the scale where needed. Far from useless!
Logged

Radio Candelstein
Pages: [1]   Go Up
  Print  
 
Jump to:  

AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands
 AMfone © 2001-2015
Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Page created in 0.048 seconds with 19 queries.