The AM Forum
October 05, 2024, 09:39:16 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Calendar Links Staff List Gallery Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: PWM modulator duty cycle drift?  (Read 6694 times)
0 Members and 1 Guest are viewing this topic.
SA2CLC
Member

Offline Offline

Posts: 60


« on: November 20, 2018, 03:52:01 PM »

Hello everyone,
Recently built another class e rig with UCC35701-based pwm modulator but I'm having some issues with increasing current draw when warming up. Initially thought I had a bad doorknob cap, but turned out to be the modulator itself drifting.
During warmup it increases the carrier pwm duration.
When cold, setting the carrier to lowest setting gives a duration of 35% on and gradually increases to 50% and beyond, until distorsion sets in.
Verified both the voltage to the chip which is steady at 13.2v, and also the isolated gate driver voltage which also is steady at 13.2v.
Could it be so simple that I'm using bad capacitors and/or resistors on the pcb? Anyone else had this problem?
BTW, this is based on the PUWMA pwm modulator, can add a snip of the schematic if anyone interested
//SA2CLC
Logged
M0VRF
Member

Offline Offline

Posts: 175


« Reply #1 on: November 21, 2018, 02:11:29 AM »

I use the same circuit and have never noticed that, most weird!

Can you swap out the chip?

IIRC there's only one cap and res (CT&RT) used for timing but still that's not your issue as is the % that's changing and that's set with a preset voltage on the VSCLAMP pin.

I'd monitor the preset voltage that sets your carrier level, if that's steady and the duty cycle still alters I'd change out the chip.

J.
Logged
SA2CLC
Member

Offline Offline

Posts: 60


« Reply #2 on: November 22, 2018, 11:37:21 AM »

Well, in hindsight everything is simple.
Turned out to be a leaky audio coupling capacitor feeding dc to the VSCLAMP. Replaced with a film cap, and now it works
//SA2CLC
Logged
steve_qix
Contributing
Member
*
Offline Offline

Posts: 2595


Bap!


WWW
« Reply #3 on: November 24, 2018, 10:36:33 PM »

That's good it wasn't the chip.  I've used that device for many years, and it's always been rock stable.

Logged

High Power, Broadcast Audio and Low Cost?  Check out the class E web site at: http://www.classeradio.org
KD6VXI
Contributing
Member
*
Offline Offline

Posts: 2679


Making AM GREAT Again!


« Reply #4 on: November 25, 2018, 11:25:28 AM »

Not the cheapest chip in the world, either.

The puwma is a decent pwm.  I built one, quite a few moons ago


--Shane
KD6VXI
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands
 AMfone © 2001-2015
Powered by SMF 1.1.21 | SMF © 2015, Simple Machines
Page created in 0.061 seconds with 19 queries.