NTE834 comparator output voltage
ka1tdq:
I'm using the NTE834 comparator chip for something, but the positive output voltage is 1.7 vdc when it switches and I'm wanting 5 vdc. I have a 5 vdc supply to the ship and ground is connected to -VCC. It is switching properly, because when the input to the (-) pin is 5 vdc the output goes to zero. 2.5 vdc is my reference voltage to the (+) pin. It is configured as an inverting comparator.
I need the output to drive other TTL logic, so I need 5 volts output. Datasheet is attached.
Jon
ka1tdq:
I think I found my answer. I need a pull-up resistor on the output.
Jon
ka1tdq:
Just for ha-ha’s, here’s the finished product. I also needed pull-up resistors on the buffer chip right before the FETs. It’s a logic board for something at work. An Arduino or a Raspberry Pi would’ve been more elegant, but this requires no programming.
Jon
W2PFY:
Kewl!!! Do you have a larger picture of your avatar? Inquiring minds need to see :D :D :D
ka1tdq:
Here
Navigation
[0] Message Index
[#] Next page
AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands