Need help to ID this Tube

<< < (2/2)

KB2WIG:


Breath deeply, exhale on envelope....it works.  Sometimes.

If you have a UV lamp, try illuminating the tube with the UV lamp.

good luck.

klc

W3NE:
klc's reply above is an ancient but effective method to reveal faint tube types and date codes. Open your mouth wide and slowly exhale all over the envelope surface. Moisture in your breath will condense slightly differently where the old ink still remains, possibly making the type visible under the proper light.

Another oldie is to pass the tube lightly through your hair (if any). Natural oil in the hair might make the tube type stand out.

An excellent source of information about tubes is The Tube Collectors Association www.tubecollectors.org/ where Lud Sibley, WB2EVN might be able to identify your tube from the photos.

Bob - NE

WA4WAX:
Put the tube in the freezer fro about 10 minutes, then bring it out.

With luck, you will be able to read the latent stencil.


Matt

WA2IXP:
Mark,
   Looks like its on a power supply chassis. As someone mentioned earlier octal rectifiers have unused pins missing to raise breakdown voltage between pins I think.  could it be a 6AS7 triode used as a shunt or series regulator. They actually had 2 triodes in parallel in the same envelope.  Another similar one was a 6080 but more modern in appearance. low mu very low plate resistance . If I recall one could see the grid structure between the plates and cathodes thru the glass. 

k5ygc:
Mystery solved turns out to be a 6AS7 exhaling on the tube worked. It is used on a power supply built on a rack mount Seeburg chassis and a huge Seeburg volt meter. A pair of OD3'S and 6sh7 and a 5U4 I googled the Seeburg model # and no luck finding any info on it. Thanks for all the help K5YGC Mark

Navigation

[0] Message Index

[*] Previous page