Title: Seeking Qro 2500dx info Post by: kc8gql on September 20, 2021, 06:20:24 PM I am looking for some one that can tell me value of the 1/4 watt resistor that goes from pin 2 to pin 7 on the meter switch. Thanks for your time .
Rick KC8GQL Title: Re: Seeking Qro 2500dx info Post by: WB4AM on September 20, 2021, 07:57:08 PM Hello Rick,
Do you have the manual? I have a 2500DX and I am looking at the manual. I am not seeing any 1/4 watt resistors in the circuit. I am not saying there isn't any, I just cannot find it! I will keep looking, I must be over looking that section. Ken Title: Re: Seeking Qro 2500dx info Post by: KD6VXI on September 20, 2021, 08:51:55 PM W8JI now owns Command Tech after purchasing it from An Wireless. You may try him as a last resort.
Be aware that Comand had quite a few changes, rarely documented, especially in the earlier days of the amp. In the Palstar days this was mostly stopped, but it still happened as things where sorted out. Some fitment on the earlier amps was done literally on the assembly line and QC table to take odd things, etc. --Shane KD6VXI Title: Re: Seeking Qro 2500dx info Post by: kc8gql on September 21, 2021, 08:48:21 AM It is not on my schematic either, but it is there. thanks for the info. thanks AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands
|