The AM Forum

Anyone know whose table is shown in the picture??

Would like to contact them about something shown...

(long shot)

Bear my car is right behind this guy..I was there when he arrived I'm pretty sure towing that box trailer..I think a clue might be in deciphering the logo/writing on the side..looks like some mountain amateur radio club with emergency amateur service underneath with what looks like a www address in the middle..my putor skills are lacking otherwise I cud take a shot at blowing it up..gud luk Bear..wish it was more help...73 de DAVE

Do you pay for a table space? And is it numbered?  That would return another clue.

gud luck,

klc

 Here is one of the pictures I took at NEARFEST... Hope this helps you contact him.

The fellow in the blue shirt is Gregg Fitch, KB1EZJ. He's prez at White Mt ARC in Conway NH.  Site is w1mwv.com, and you'll find contact info there.

Yep great info guys!

Except for one little thing.
Oopsy.

I'm curious/interested in the guy next to them, in specific the two boxes
stacked on the little table, looks like the awning from an RV on the right, rug on the
ground.

No biggie... probably they are not what I think they might be anyhow.

                              _-_-

Welllll.  If you can't give a better clue than that, it's hard to give better info.  Dontcha suppose that Greg might possibly know the neighbor guy?  Worth a try.  What would Inspector Columbo do in a case like this?  Yep, he'd follow the leads.  Get out your trenchcoat and cigar....

Rpt... Are the spaces numbered?


KLC

Not that I am aware of.
It's first come, first served for the most part, especially outside down the hill...

                     _-_-

Unless it's changed, there are no spaces. Set up where you like.

Ok.... well that avenue of discovery is closed.

KLC

Bear,
They look like HP spectrum analyzers. At first I thought they were vector network analyzers  like a 8753 but they are single port.

Joe 

HP?

I thought they might be Panasonic test gear.

tnx...
...think this ship has sailed anyhow.

Is the distortion low enough?


klc

That would be the question that would be answered with the VP7725...
But the short version is that once you start dorking with hifi amplifiers, be they opamp level or
speaker power level that are <0.001%, then yes, you can not have too good of a distortion
analyzer. If you want to know what is going on... and, yes, there are audible differences
in opamps and power amps that measure steady state <0.001%THD. Nothing of interest
for ham applications though.

                        _-_-bear