Title: The original Dutchtronix scope clock kits are available again. Post by: Opcom on April 27, 2016, 06:35:45 PM I have no pecuniary interest here but I like scopeclocks and the kits were discontinued for a while. Unlike the Sparkfun SMD pre-assembled board that was based on these, this is the original type through-hole kit and improved over the previous version and from the original person. This is the original Dutchtronix scopeclock. AMfone - Dedicated to Amplitude Modulation on the Amateur Radio Bands
All you need is this and an old scope. (and some time and solder) From: jdr at Dutchtronix Sent: Wednesday, April 27, 2016 4:24 PM Subject: RE: scope clock Dear Scope Clock Enthusiast Good news! A complete Dutchtronix AVR Oscilloscope Clock Hardware 3.1, Firmware 4.2 is now available. You don’t need anything else to build the project (but you will need an oscilloscope ). Also included are the BNC connectors and the full serial interface, with DB-9 connector. Please double check the complete parts list: http://www.dutchtronix.com/AssemblyH3-1-Enhanced.htm#PartsList You can now purchase the kit directly on my website: http://www.dutchtronix.com/ScopeClockH3-1-Enhanced.htm Thanks for your interest. Sincerely Jan de Rie Dutchtronix |